Skip to content

The simple explanation

How does infrared heating work?

Infrared panels send radiant heat towards people and surfaces. Those warmed surfaces then give heat back to the room.

Plan the position as well as the output

Wall or ceiling mounted?

Both arrangements can work when the selected heater is suitable for that mounting position and can radiate towards the area being used.

Illustration comparing a wall-mounted infrared panel facing seating with a ceiling-mounted panel radiating down towards people and room surfaces
Illustration only. The arrows explain radiant paths; they are not a measured heat-coverage map or an installation drawing.

Wall mounting

Consider where people sit and whether furniture, curtains or partitions would obstruct the panel. Check the permitted orientation and clearances for the exact model.

Ceiling mounting

Consider the panel position above the occupied area, the strength of the fixings and the manufacturer’s mounting height. A panel suspended below the ceiling has its own mounting height.

Room height alone does not establish that a ceiling installation is suitable. Use the current product instructions and ask us to review unusual layouts. Check model-specific mounting information or start a room estimate.

Radiant warmth, without the jargon

All warm objects transfer heat in more than one way. With a conventional convector heater, a large share of the heat warms the air close to the heater; that air circulates around the room. An infrared panel adds more direct radiant warmth: energy travels from the panel and is absorbed by people and surfaces it reaches.

The sensation can be like standing in winter sunshine: you may feel warmth on the side facing the panel even before the whole room air has warmed. The result depends on panel output, where it is placed, what it can “see”, and how the room is used.

Useful distinction

Infrared describes a way heat is transferred. It doesn’t mean every infrared product has the same output, coverage, controls or running cost.

Ceiling-mounted infrared panel directing radiant energy towards a person, sofa and floor
Radiant heat reaches people and surfaces in its path.

What to consider

It’s about more than the panel.

Room and building

Room dimensions, insulation, glazing, draughts and the temperature you want all affect the amount of heat needed.

Position and coverage

Furniture, doors and other obstructions can block radiant warmth. Multiple panels can provide more even coverage than one panel in a poor position.

Controls and routine

A suitable thermostat and schedule can help heat rooms when needed. The benefit depends on how you set and use the system.

Is infrared suitable as the main heating?

It can be used as a room’s main heat source where the system is properly sized and controlled. Whether it is a good choice for an entire home depends on the building, electricity tariff, comfort expectations and alternatives. Infrared panels do not heat domestic hot water, so a separate hot-water system is needed.

Does it reduce damp or mould?

Infrared heating is not a damp treatment. Moisture, ventilation, insulation and cold surfaces still matter. If a property has persistent damp or mould, address the underlying cause and take advice rather than relying on a heater alone.

Do infrared panels use less electricity?

Like other direct electric resistance heaters, panels turn electricity into heat at the point of use. A household may use less energy if it can heat a smaller occupied zone, choose different comfort conditions or control heating more closely. The outcome depends on the home and how the heating is used; no saving is automatic.

Independent overview: Energy Saving Trust: infrared heating explained.

Explore the science

Read our science of infrared heating guide for near, mid and far infrared, wavelength and temperature, entropy and energy efficiency.

Estimate a room